Disk surface test aomei6/10/2023 Scan log in Disk Scanner Use the following steps to isolate bad sectors:ġ. According to Scan_log, we know where those bad sectors located, and now it's easy for us to isolate them. Open Scan_log.txt, it locates at the same directory with dm.exe. When we located bad sectors in hard drive, we need to find bad sectors in the log file, so that we can isolate bad sectors by Partition Expert. fix found errors Step 2: Isolate or Block Bad Sectors. OK, right now, bad sectors are marked and fixed, but they still there, NTFS file system will not use marked bad sectors, but the best way to avoid further damage is to isolate bad sectors. We can use Check Volume function in Partition Expert to fix found errors and fix found bad sectors. When Scanner finished checking bad sectors, good sectors are marked as green, bad sectors are marked as red. We strongly recommend using this function, which will scan specific area on your disk if you have any clue of which section may have bad sectors, it's also more precise to isolate bad sectors. Select a disk to scan if you have multiple disks. Run Macrorit Disk Scanner, or Macrorit Partition Expert – Surface Test.Intend to use chkdsk to isolate bad sectors?īut the command: chkdsk check disk and repair bad sectors, but it can not isolate bad sectors Step 1: Scan Bad Sectors Locate bad sectors on the hard drive first: To isolate bad sectors on hard drive needs to find bad sectors first, and isolate them into a new partition and hide partition so that Windows won't read-write and make situation worse again.
0 Comments
Leave a Reply. |